Manual
25Publication IASIMP-QS008A-EN-P - March 2009 25
Chapter
3
DataSite and Logix Integration
Introduction
In this chapter, you configure the DataSite unit, download the ControlLogix user program,
configure the ProSoft (MVI56-MNET) Modbus TCP/IP communication module, and connect all
system devices.
Before You Begin
• Complete your system hardware selection (Chapter 1).
• Complete your system layout and wiring (Chapter 2).
• Load all DataSite software on your computer as listed in the Preface on page 10. In this
chapter, you will use the DS FloConfig and RSLogix 5000 software.
• Assign IP addresses to all devices on network. The table lists IP addresses used in this
quick start.
This chapter assigns IP addresses to the 1756-ENBT Ethernet module, the DataSite unit, and
the Prosoft MV156-MNET module. For details on how to assign an IP address to the
PanelView Plus terminal, refer to the PanelView Plus Terminals User Manual, publication
2711P-UM001
. For the other devices, refer to the manufacturer’s user manual.
What You Need
• Personal computer or laptop
• Hardware:
– 1758-FLOxxx DataSite Unit
– 1756-L63 ControlLogix controller
– 1756-ENBT EtherNet/IP module
Device IP Address Device IP Address
1756-ENBT Ethernet module 192.168.10.90 ProSoft MV156-MNET module 192.168.10.94
Master radio 192.168.10.91 Personal computer 192.168.10.95
Remote radio 192.168.10.92 PanelView Plus 1000 terminal 192.168.10.96
DataSite unit 192.168.10.93