Installation and Upgrade Guide

Publication 1757-IN510A-EN-P - October 2003
ProcessLogix Server Upgrade Procedures 4-15
Disconnect Redundant Servers
If you have a redundant Server pair, complete these steps on both
SERVERA and SERVERB. If you have a non-redundant Server, return
to the checklist that led you to this task.
1. Disconnect the Ethernet network cable(s).
2. Use the PING command to confirm that the Servers can no
longer communicate with each other by name or IP address.
The network cables should be reconnected only after both
Servers have been upgraded.
3. Close the DOS window.
Saving Data to a Remote PC is complete.
Return to the checklist that led you to this task.
Removing ProcessLogix
R500.1 Software
This procedure completely removes ProcessLogix R500.1 SP2 software
from your system, including:
• SQL
• Knowledge Builder
• RSLinx
• Engineering Tools
• Server and/or Station
Removing Selected ProcessLogix R500.1 Components
1. If necessary, logon to the system as ps_user.
2. Click Star t ⇒ Settin gs ⇒ Control Panel.
ATTENTION
!
Before installing or uninstalling any software
component, you MUST exit all ProcessLogix
applications and stop all ProcessLogix services. You
must complete the procedure in
Stopping
ProcessLogix Applications and Services on page 8-1
before continuing.
If you have a redundant server pair, you must
complete this procedure on SERVERB first. Then
complete the entire procedure again on SERVERA.