Installation and Upgrade Guide

Publication 1757-IN510A-EN-P - October 2003
Additional Redundant Server Procedures 6-5
Changing TCP/IP address on a Secondary Server (SERVERB)
If you need to change the TCP/IP address on SERVERB to agree with
Hosts file entries, do the following:
1. Click Start ⇒ Settings ⇒ Control Panel.
2. Double-click Network and Dial-up Connections.
3. Right-click the Local Area Connection icon and select
Properties.
4. Select TCP/IP Pr otocol and click Pr oper ties.
5. Enter the TCP/IP address and appropriate Subnet mask.
Changing the ProcessLogix License
If the license for redundant Servers has been installed, skip to Setting
up Primary Server (SERVERA) on page 6-6.
Perform the following procedure on Primary (SERVERA) and
Secondary (SERVERB) Servers.
1. Click Start ⇒ Pr ogr ams ⇒ ProcessLogix Server ⇒ Start-Stop
ProcessLogix Server to call up the ProcessLogix Server dialog
box.
2. With the Full Mode version of the dialog box active, click the
Database Only option.
3. Click Yes to confirm the action and wait for the Server to change
its state.
TIP
Networked PCs must have unique addresses. For
example, if the address for SERVERA is 192.168.0.1,
you could change the SERVERB address to
192.168.0.2.
TIP
To display the Full Mode version of the ProcessLogix
Server dialog box, click the icon on the left of the
title bar and click Advanced
⇒ Full Mode.
A checkmark appears in front of the Full Mode
selection to show that it is active.