Installation and Upgrade Guide Instruction Manual

Publication 1757-IN500A-EN-P - September 2002
iv Table of Contents
Saving R400.0 Data to a Remote PC. . . . . . . . . . . . . . . . . . . . . . . . . 4-22
Networking an R400.0 Server to a Remote PC . . . . . . . . . . . . . 4-22
Transferring Data. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-22
Removing ProcessLogix R400.0 Software . . . . . . . . . . . . . . . . . . . . 4-23
Removal of Selected ProcessLogix R400.0 Components . . . . . 4-23
Remove ProcessLogix Server Components . . . . . . . . . . . . . . . . 4-24
Remove Remaining ProcessLogix R400.0 Components . . . . . . 4-25
Verifying and Finalizing Component Removal . . . . . . . . . . . . . 4-26
Installing ProcessLogix R500.1 Software . . . . . . . . . . . . . . . . . . . . . 4-27
Finalizing R400.0 to R500.1 Upgrade . . . . . . . . . . . . . . . . . . . . . . . . 4-27
Reconnect Redundant Servers . . . . . . . . . . . . . . . . . . . . . . . . . . 4-27
Transferring R400.0 Data to the R500.1 Server. . . . . . . . . . . . . 4-27
Restoring ProcessLogix Data. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-28
Importing the Engineering Database . . . . . . . . . . . . . . . . . . . . . 4-29
Changing the default Operator's password . . . . . . . . . . . . . 4-29
Adding Saved Device Templates Using Fieldbus
Library Manager . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-30
Importing the Database Using Control Builder . . . . . . . . . 4-31
Restoring the ProcessLogix Server Points Database . . . . . . . . . 4-32
Restoring Server Redundancy . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-34
Upgrading Hardware Component Firmware . . . . . . . . . . . . . . . 4-34
Checking Control Builder Operation and Logging On . . . . . . . 4-35
Changing the default Operator's password . . . . . . . . . . . . . 4-35
Reloading Controllers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-36
Backing Up a ProcessLogix Server Hard Drive to Tape . . . . . . 4-36
Chapter 5
ProcessLogix Client Installation
and Upgrade Procedures
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1
Operating System Support. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-3
Windows 2000 Professional . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-3
Windows XP Professional. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-3
Windows 2000 Server . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-3
Windows 2000 Professional Client Installation Scenarios . . . . . . . . . 5-4
Clean Install: Windows 2000 Professional . . . . . . . . . . . . . . . . . . 5-4
Upgrade R400.0 Windows 2000 Professional Client
to R500.1 Windows 2000 Professional Client. . . . . . . . . . . . . 5-4
Upgrade R400.0 Windows NT 4.0 Client to R500.1
Windows 2000 Professional Client (Clean Install) . . . . . . . . . 5-5
Upgrade R320.0 Windows NT 4.0 Client to R500.1
Windows 2000 Professional Client (Clean Install) . . . . . . . . . 5-6
Windows XP Professional Client Installation Scenarios . . . . . . . . . . 5-7
Clean Install: Windows XP Professional . . . . . . . . . . . . . . . . . . . 5-7
Upgrade R400.0 Windows 2000 Professional Client
to R500.1 Windows XP Professional Client . . . . . . . . . . . . . . 5-7