Installation and Upgrade Guide Instruction Manual

Publication 1757-IN500A-EN-P - September 2002
8-28 Supplementary Procedures
2. Create redundancy modules.
Navigate in Knowledge Builder to Control Building Guide⇒Hardware
Module Creation
⇒Creating Redundancy Modules for more information
about configuring 1757-SRMs in Control Builder.
3. Once the redundant CPM is created in the Project tab, re-assign the
modules unassigned from the previous non-redundant CPM to the CEE
associated with the new redundant CPM.
Navigate in Knowledge Builder to Control Building Guide⇒Control Module
Creation
⇒Assigning the CM and IOMs to the CEE for more information.
4. Load the primary and secondary CPMs and RMs to the Controllers.
Navigate in Knowledge Builder to Control Building Guide⇒Control Strategy
Loading
⇒Loading Objects to the CPM for more information.
This completes the upgrade to a Redundant Chassis Pair.