Installation and Upgrade Guide Instruction Manual

Publication 1757-IN500A-EN-P - September 2002
5-24 ProcessLogix Client Installation and Upgrade Procedures
Setting Up a Station With a Non-redundant Server
Use the following procedure to set up the ProcessLogix Client node to access
data in a networked ProcessLogix non-redundant Server node.
1. On the Server, click Start ⇒ Programs ⇒ ProcessLogix Server ⇒
Start-Stop ProcessLogix Server to call up the ProcessLogix Server
dialog box. Check that the Server is running and close the dialog box.
OR
2. On the Client, click Start ⇒ Programs ⇒ ProcessLogix Client
Software
⇒ Station.
3. Click Cancel at the Unable to connect prompt, if applicable.
4. Click Station ⇒ Connect to call up the Station Connect dialog box.
5. Highlight Default and click Edit Connection.
TIP
You must define the appropriate Station items in Quick
Builder on the Server in order for the Client Station to
connect.
Navigate in Knowledge Builder to Server and Client
Configuration Guide
⇒ Understanding and Configuring
Points
⇒ History Collection and Archiving ⇒ History Archiving for
more information.