Installation and Upgrade Guide User guide

Publication 1757-IN032B-EN-P - April 2001
1-84 System Software Upgrade Procedures
Setting Up a ProcessLogix Client With a Non-redundant Server
Use the following procedure to set up the ProcessLogix Client node to
access data in a networked ProcessLogix non-redundant Server node.
1. On the non-redundant Server node, click
Start
⇒Programs⇒ProcessLogix Server⇒Start-Stop ProcessLogix
Server to call up the ProcessLogix Server dialog box. Check that the
Server is running and close the dialog box.
OR
2. On the Client Station node, click Start
⇒Programs⇒ProcessLogix
Client Software
⇒Station.
3. Click Cancel at the Unable to connect prompt, if applicable.
4. Click Station
⇒Setup to call up the Station Setup dialog box.
5. Click the down arrow button in the Server Connection field and
select Network (TCP/IP).
6. Click Setup in the Server Connection field to call up the
TCP/IP Setup dialog box. Make these entries:
a. Key in the name or IP address of the non-redundant Server
(PLX1) in the Server Name field.
The PLX1 is the default Server name assigned by the factory. It
is used for example purposes only.
b. Select the appropriate option, Static or Rotary.