User Manual Manual

Rockwell Automation Publication 1757-UM012A-EN-P - July 2011 47
Create an RSFieldbus Software Project Chapter 3
Create a Function Block in Logical Component
Follow the same procedures as documented on page 40, except make sure you add
the blocks in the Process Cell window.
An attached function block in the Process Cell will have a question mark until the
block is attached to a device.
Do these steps to attach a function block to a control module.
1. In the Process Cell window, right-click the control module to which the
block is being attached and choose Attach Block.
The Attach Block dialog box appears.
2. Select the desired block and click OK.
The block is added to the logical component.