Manual

Publication 1757-UM007D-EN-P - December 2008 25
Configure the 1757-ABRIO Module Chapter 2
As illustrated in the 1/2-slot addressing table below, the controller
addresses 1/2 of an I/O module slot as one I/O group. For example,
for a chassis at rack 1, starting I/O group 0, a block transfer module in
the first slot would be at address rack 1, I/O group 0, slot 0. A module
in the next slot would be at rack 1, I/O group 2, slot 0.
Configuring Block Transfer
Modules
When you add a block transfer module, the configuration dialog box
for that module opens. The contents of the dialog box are specific to
each module type.
See Supported 1771 Modules
on page 83 or the online help for
information on configuring individual modules.
To edit the configuration for a module, double-click the module in the
network tree, or right-click the module and select Configure.
1/2-Slot Addressing
Slot in chassis0123456789101112131415
Rack 1111222233334444
I/O Group 0246024602460246
Slot 0000000000000000
TIP
You cannot change the location of a module in the
configuration once you have created it. You must delete the
module and create a new one at the new location.