Installation Instructions User Manual

22 Rockwell Automation Publication 1756-IN005C-EN-P - March 2014

Chapter 1 Install Chassis and Power Supplies

5. Leaving the far-left bottom tab open for functional ground, install the

remaining tab screws.

6. Align the power-supply circuit board with the card guides on the left side

of the chassis and slide the power supply back until it is flush with the front

of the chassis.

7. Tighten the top and bottom screws to fasten the power supply to the

chassis.

20290-M

Leave far-

left bottom

tab open.

Card Guide

43614