Manual

254 Publication 1756-UM009C-EN-P - December 2010
Chapter 11 Calibrate the ControlLogix Analog I/O Modules
5. Click the Calibration Tab on the Module Properties dialog box.
6. Click Start Calibration to access the Calibration Wizard to step through
the process.
If your module is not in Program mode, a warning message appears.
You must manually change the module to Program mode before
clicking Yes.
IMPORTANT
The ‘Error’ for channel 5 shows that during the previous
calibration the process was not successful for this
particular channel. We suggest a valid calibration be
performed for all channels.
See
page 258 for a successful calibration status.