Manual

Publication 1756-UM009C-EN-P - December 2010 231
Configure ControlLogix Analog I/O Modules Chapter 10
For more information on the ControlLogix ControlNet module, see
ControlNet Modules in Logix5000 Control Systems,
publication
CNET-UM001 .
For more information on the ControlLogix EtherNet/IP Bridge
module, see EtherNet/IP Modules in Logix5000 Control Systems User
Manual, publication
ENET-UM001 .
6. Repeat steps
1 … 5 to configure a communication module for the
remote chassis.
7. Configure the communication module in the remote chassis.
Now you can configure the remote I/O modules by adding them to the
remote communication module. Follow the same procedures as you do
for configuring local I/O modules, starting on
page 202 .
8. Click Reset for the appropriate point setting in the Reset Latched
Diagnostics column.
9. Click OK.