Manual

Publication 1756-UM009C-EN-P - December 2010 229
Configure ControlLogix Analog I/O Modules Chapter 10
Reconfigure Parameters
in Program Mode
Change the module from either Run or Remote Run mode to Program mode
before changing configuration in the Program mode. Follow these steps.
1. At the top, left corner of the RSLogix 5000 software program, click the
status icon.
2. Choose Program mode.
A window appears asking if you want to change the controller mode to
remote program mode.
3. Click Yes.
4. Make any necessary changes. For example, the RPI can be only changed
in Program mode.
5. Do one of the following:
• Click Apply to store a change but stay on the dialog box to choose
another tab.
• Click OK if you are finished making changes.