Manual

214 Publication 1756-UM009C-EN-P - December 2010
Chapter 10 Configure ControlLogix Analog I/O Modules
Calibration Tab
The Calibration tab on the Module Properties dialog box lets you recalibrate
the default factory calibrations, if necessary. Calibration corrects any hardware
inaccuracies on a particular channel.
See
page 233 in Chapter 11 for specific module calibrations.
Although each dialog box maintains importance during online monitoring,
some of the tabs, such as the Module Info and Backplane, are blank during the
initial module configuration.
Some of the analog input modules, for example the 1756-IR6I and 1756-IT6I
modules, have additional configurations. These configuration dialog boxes are
explained on the following pages.