Manual

Publication 1756-UM009C-EN-P - December 2010 199

Chapter

Configure ControlLogix Analog I/O Modules

Introduction

You must configure your module upon installation. The module will not work

until it has been configured.

In most cases, you will use RSLogix 5000 programming software to configure

your analog I/O module. The programming software uses default

configurations, such as RTS, RPI, and so forth, to get your I/O module to

communicate with the owner-controller.

However, there are situations in which you might want to modify the default

settings. You can maintain custom settings on tabs from the Module

Properties dialog box. This section provides step-by-step instructions for

creating default and custom configurations

Topic Page

Full Configuration Profile Diagram 201

Create a New Module 202

Modify Default Configuration for Input Modules 207

Configure the RTD Module 215

Configure the Thermocouple Modules 216

Modify Default Configuration for Output Modules 218

Download Configuration Data to the Module 225

Edit Configuration 226

Reconfigure Module Parameters in Run Mode 227

Reconfigure Parameters in Program Mode 229

Configure I/O Modules in a Remote Chassis 230

View Module Tags 232