User Manual User guide

56 Publication 1756-UM534B-EN-P - November 2010
Chapter 2 Configure Scanner Mode
Re-Map Command
Use the Re-Map All command to clear all previous mappings and
automatically map all discrete and block transfer data to connections.
From the Map menu, select Re-Map All.
See Aliases
on page 84, for exporting and importing aliases.
IMPORTANT
If you change mappings, make sure you clear the output table in
the ControlLogix controller to prevent inadvertently writing to
an incorrect I/O location. If you leave a value behind in the
output table, it now points to something else on the Remote I/O
network. To clear the output table, set the outputs to 0. You
must also re-import the aliases.
ATTENTION
If you remap I/O data, you should export aliases and re-import
them into the RSLogix 5000 project so the control program uses
the new assignments.