User Manual User guide

Publication 1756-UM534B-EN-P - November 2010 25
The 1756-RIO Module-Getting Started Chapter 1
On the Module Properties dialog box, from the General tab, you can
assign the module name, description, slot number, and module
definition.
The Module Definition dialog box displays.
4. Click OK on the Module Definition dialog box.
5. Click Yes to accept any changes.
6. Click OK again on the bottom of the General tab.
Item Description
Name Choose a name that easily identifies the module.
Description The Description field is optional.
Slot The Slot field must match the slot number of the 1756-RIO module’s location in the chassis.
Module Definition-
Change … button
Click on the Change … button to change the Series, Revision, Electronic Keying, Mode (scanner or adapter),
or Number of Input or Output Tags. The Module Definition dialog box displays.