User Manual

Rockwell Automation Publication 1756-UM540A-EN-P - May 2014 121
Chapter 7
Configure ControlLogix Isolated Analog
I/O Modules
You must configure your isolated analog I/O module upon installation. It does
not work if it is not configured.
This section describes how to use the Logix Designer application to configure
I/O modules in a local chassis. If you plan to use the I/O module in a remote
chassis, you must add a ControlNet or EtherNet/IP communication module to
the I/O configuration tree:
• For more information on the ControlLogix ControlNet module, see
ControlNet Modules in Logix5000 Control Systems,
publication CNET-UM001
.
• For more information on the ControlLogix EtherNet/IP Bridge module,
see EtherNet/IP Modules in Logix5000 Control Systems User Manual,
publication ENET-UM001
.
Topic Page
Create a New Module 122
Edit the Configuration 125
Copy Channel Configuration 134
View the Module Tags 136
IMPORTANT
This chapter describes how to configure you module with Logix Designer
application, version 21 and later.
You can use the ControlLogix isolated analog I/O modules in RSLogix 5000
software projects as well.
You must install AOPs to use the modules in any Logix Designer application
or RSLogix 5000 software project.