Owner manual

Rockwell Automation Publication 1756-UM533C-EN-P - February 2011 89

Chapter

Configure the Modules with RSLogix 5000

Software

Introduction

The information in this chapter describes how to configure the ControlLogix

HART analog I/O modules with RSLogix 5000 software.

The table explains the topics discussed in this chapter.

Create a New Module

Do these steps to add a ControlLogix HART analog I/O module to your

RSLogix 5000 project.

The screen facsimiles show examples for the 1756-IF8H module, but the

procedures are the same for the 1756-IF16 H and 1756-OF8H modules.

1. From the I/O Configuration tree, right-click the 1756 backplane and

choose New Module.

Topic Page

Create a New Module 89

General Tab 91

Connection Tab 93

Module Info Tab 94

Configuration Tab - Input Modules 96

Alarm Tab - 1756-IF8H Module 103

Configuration Tab - Output Module 105

Output State Tab - Output Module 107

Limits Tab - Output Module 109

HART Device Info Tab 111

Data in the Input Tags 113

IMPORTANT

You cannot make changes to any field in these tabs if you are in Hard Run

mode. Hard Run mode means that the keyswitch is in the Run position.