Owner manual

Rockwell Automation Publication 1756-UM533C-EN-P - February 2011 107
Configure the Modules with RSLogix 5000 Software Chapter 7
Output State Tab -
Output Module
Use the following information to configure the parameters on the
Output State tab.
With an individual channel button selected, use this information to configure the
parameters in the Channel box that apply to the individual channels.
Ramp Rate
The ramping rate, which is set up on the Limits tab, limits the speed at which an
analog output signal can change. This prevents fast transitions in output from
damaging equipment that the output controls.
This feature is available in Hard Run mode.
Table 27 - Pass -through Setting, Ratio, and Priority
Setting Scan:Pass-through ratio Gives priority to
Once per channel scan 1:1 Asset management
Once per two channels scanned 1:2 Default setting
Once per module scan 1:8 Input tag scan