Installation Instructions User Manual

4 ControlLogix™ Memory Board
Publication 1756-IN033B-EN-P - November 2000
What You Need to Do
To guard against ESD damage, take these precautions:
To install the memory board, do these steps:
• Step 1: Verify that You Have All the Components
• Step 2: Remove the Controller from the Chassis
• Step 3: Remove the Side Plate of the Controller
• Step 4: Remove the Existing Memory Board (If Any)
• Step 5: Install the Memory Board
• Step 6: Replace the Side Plate
• Step 7: Attach Labels
ATTENTION
!
Electrostatic discharge can damage the components. Follow
these guidelines:
• touch a grounded object to discharge potential static
• wear an approved grounding wriststrap
• do not touch connectors or pins on component boards
• do not touch circuit components inside the controller
• if available, use a static-safe work station
• when not in use, store each component in the anti-static
packaging in which it was shipped