Installation Instructions User Manual

6 Analog Encoder (AE) Servo Module
Publication 1756-IN047D-EN-P - March 2001
• 1756-TBCH 36-position cage clamp RTB
• 1756-TBS6H 36-position spring clamp RTB
You received the following components with your RTB:
• 1756-TBH standard-depth RTB housing
• wedge-shaped keying tabs and U-shaped keying bands
• RTB door label
Installing the Module
To install the AE module:
1. Align the module circuit board with the top and bottom chassis
guides.
WARNING
!
When you remove or insert an RTB with field-side
power applied, unintended machine motion or loss of
process control can occur. Exercise extreme caution
when power is applied. Failure to observe this caution
can cause personal injury.