Owner manual

10 GuardLogix Controllers
Publication 1756-IN045E-EN-P - October 2009
Check the BAT Status Indicator
Follow these steps for both the 1756-L6xS controller and 1756-LSP safety partner.
1. Turn on the chassis power.
2. Check the status of the BAT indicator.
3. Check that the battery is correctly
connected to the controller or safety
partner.
4. If the BAT status indicator remains on, install another battery.
5. If the BAT status indicator remains on after you complete step 4, contact
your Rockwell Automation representative or local distributor.
Check the OK Status Indicator
Follow these directions for both the 1756-L6xS controller
and 1756-LSP safety partner.
If Then
Off Go to Update the Controller on page 11.
On Go to step 3.
If the OK
Indicator
is
Then Next step
Solid
green
The controller is OK and its
firmware has been updated.
No further action is required.
Flashing
red
The controller is OK but it
requires a firmware update.
Go to Update the Controller
below.
BAT Status
Indicator
OK
Status
Indicator