Owner manual

Rockwell Automation Publication 1756-UM022A-EN-P - November 2012 19
Chapter 2
Install the Controller
Precautions
Read and follow these precautions for use.
Environment and Enclosure Information
Topic Page
Precautions 19
Make Sure That You Have All of the Components 22
Install a Chassis and Power Supply 22
Install the Controller into the Chassis 23
Insert or Remove a Memory Card 24
Make Communication Connections 27
Update the Controller 29
Choose the Operating Mode of the Controller 31
Uninstall an Energy Storage Module (ESM) 33
Install an Energy Storage Module (ESM) 34
ATTENTION: This equipment is intended for use in a Pollution Degree 2 industrial environment, in overvoltage Category II
applications (as defined in IEC 60664-1), at altitudes up to 2000 m (6562 ft) without derating.
This equipment is not intended for use in residential environments and may not provide adequate protection to radio
communication services in such environments.
This equipment is supplied as open-type equipment. It must be mounted within an enclosure that is suitably designed for those
specific environmental conditions that will be present and appropriately designed to prevent personal injury resulting from
accessibility to live parts. The enclosure must have suitable flame-retardant properties to prevent or minimize the spread of
flame, complying with a flame spread rating of 5VA or be approved for the application if non-metallic. The interior of the
enclosure must be accessible only by the use of a tool. Subsequent sections of this publication may contain additional
information regarding specific enclosure type ratings that are required to comply with certain product safety certifications.
In addition to this publication, see the following:
• Industrial Automation Wiring and Grounding Guidelines, publication 1770-4.1
, for additional installation requirements
• NEMA Standard 250 and IEC 60529, as applicable, for explanations of the degrees of protection provided by enclosure