User Manual

68 Rockwell Automation Publication 1756-UM005B-EN-P - January 2013
Chapter 4 Install the Module
Remove the Removable
Terminal Block from the
Module
If you need to remove the module from the chassis, you must first remove the
RTB from the module.
1. Unlock the locking tab at the top of the module.
2. Open the RTB door using the bottom tab.
3. Hold the spot marked PULL HERE and pull the RTB off the module.
ATTENTION: Be sure that power is removed or the area is nonhazardous before
proceeding.
WARNING: When you connect or disconnect the Removable Terminal Block
(RTB) with field side power applied, an electrical arc can occur. This could cause
an explosion in hazardous location installations.
IMPORTANT
Do not wrap your fingers around the entire door. A shock hazard exists.
20855-M