Instruction Manual

76 Publication 1756-UM525A-EN-P - June 2003
Chapter 4 Using the 1756-HYD02 Module Features
Tag Tab
Use this tab to change the name and description of the axis. When you are
online, all of the parameters on this tab transition to a read-only state, and
cannot be modified. If you go online before you save your changes, all pending
changes revert to their previously-saved state.
The table below lists the features available on the Tag tab. Some of these
features cannot be changed on this screen however.
Chapter Summary and
What’s Next
In this chapter, you read about the 1756-HYD02 module’s features.
Chapter 5 describes
Troubleshooting the 1756-HYD02 Module .
Fault Type: Definition:
Name Displays the name of the current tag.
Description Displays the description of the current tag, if any is available.
Tag Type Indicates the current tag type.
• Base
• Alias
• Consumed
Data Type Displays the data type associated with the current tag.
Scope Displays the scope of the current tag. For axis tags, the scope must be controller scope.
Style Displays the default style in which to display the value of the tag. Note that style is only applicable to an
atomic tag; a structure tag does not have a display style.