Instruction Manual

31Publication 1756-UM525A-EN-P - June 2003 31
Chapter 3
Configuring the 1756-HYD02 Module
This chapter describes how to configure a ControlLogix Hydraulic Servo
module.
You must configure your module upon installation. The module does not
work until it has been configured.
Using RSLogix 5000
Configuration Software
Use RSLogix 5000 software, version 12 or greater, to configure your
ControlLogix Hydraulic Servo module.
For information about: See page:
Overview of the Configuration Process 32
Creating a New Module 33
Configuring General Module Features 35
Configuring the Axes Features 36
Downloading New Configuration Data 37
Editing Configuration 38
Reconfiguring Module Parameters in Run Mode 39
Reconfiguring Module Parameters in Program
Mode
39
IMPORTANT
The ControlLogix Hydraulic Servo module can only be used in a
local chassis.