Instruction Manual

13Publication 1756-UM525A-EN-P - June 2003 13

Chapter

Installing the 1756-HYD02 Module

What This Chapter Contains

This chapter describes how to install the 1756-HYD02 module.

The 1756-HYD02 module mounts in a ControlLogix chassis and uses a

removable terminal block (RTB) to connect all field-side wiring.

Before you install your module, make sure you:

• install and ground a ControlLogix chassis and power supply.

• order and receive an RTB, and its components, for your application.

For more information on all the ControlLogix chassis and power supplies, see

the ControlLogix Selection Guide, publication

1756-SG001

Note the Power

Requirements

This module receives power from the 1756 chassis power supply and requires

two sources of power from the backplane:

• 700mA at 5.1V

• 2.5 mA at 24V

Add this current to the requirements of all other modules in this chassis to

prevent overloading the backplane power supply.

For information about: See page:

Installing the Module 14

Keying the Removable Terminal Block 15

Connecting Wiring 16

Assembling The Removable Terminal Block and

the Housing

Installing the Removable Terminal Block 26

Removing the Removable Terminal Block 28

Removing the Module from the Chassis 29