Owner's manual

FACTORYTALK HISTORIAN ME USER’S GUIDE
262
 The processor is in Remote Run mode.
To configure the module in RSLogix 5000:
1. Launch RSLogix 5000 by going to Start > Programs > Rockwell Software >
RSLogix 5000 Enterprise Series> RSLogix 5000. You can also double-click on
an .ACD file to launch RSLogix 5000.
2. Open the RSLogix 5000 project file. Select File > Open.
3. Right-click on the I/O Configuration folder and select New Module.
4. Under Specialty, select the module. You may select either the 1G or the 2G
module, depending on your installation.
5. Click [OK] and the module property sheet will open, allowing you to configure
the module.
6. Enter the following module properties on the General tab:
a. Name
This step is optional. Enter the host name for the module.
b. IP address