Owner's manual

D • RSLOGIX 5000 ADD-ON PROFILE
261
e. Enter the Ethernet module IP address in station 0 (the left-most module).
f. Click [OK] to save the configuration.
g. Click [Close] to exit the Configure Drivers dialog.
h. Exit RSLinx Classic.
Configuring the Module in RSLogix 5000
This section assumes that:
 The project file that contains the controller programming and configuration
information (also called the .ACD file) already exists in RSLogix 5000.
 Communication devices have already been added to the I/O Configuration folder.
 Logic, tags, and communication path are defined.