Owner's manual

9 • MANAGING SECURITY
181
1. Under the FactoryTalk Historian SE/PI Server Parameters section, enter the host
name or IP address of your PI server in the Host Server field.
2. Click [Test Connection].
An informational message displays at the top of the page if the connection is
successful. In addition, a green checkmark displays next to the [Test Connection]
button. This indicates that the module can establish a connection to your PI server.
If this checkmark and message do not appear, check your work and try again.
3. Click [Save].
You have completed the trust configuration process.
Ensure that licenses
to support the FTMS
point source have
been activated on the
PI server before you
configure Data
Transfer.