User Manual

Rockwell Automation Publication ENET-IN002F-EN-P - January 2014 39
Install a 1768 EtherNet/IP Communication Module Chapter 2
This graphic shows the process used to set your module’s IP address.
Figure 2 - How Your Module’s IP Address is Set
If you need to reset your module’s settings to factory default settings during
normal module operation, see
Reset the Module IP Address to a Factory Default
Value on page 46.
These tools are used in this sequence to set the network IP address.
1.
Set the Network IP Address with a BOOTP/DHCP Server.
2.
Set the Network IP Address with RSLinx Software or the Studio 5000
Environment.
Module Powerup
Module has an IP
address.
Is DHCP or
BOOTP
enabled?
YesNo
Module requests
address from DHCP/
BOOTP server.
Adapter uses IP address
stored in nonvolatile
memory.