Installation Instructions User Manual

Publication

1756-IN612B-EN-P - December 2009

Use a USB cable to connect your computer to the USB port. The connection

lets you download programs to controllers and configure Ethernet modules

directly from your computer.

The USB cable is not to exceed 3.0 m (9.84 ft) and must not contain hubs.

Apply Chassis Power and Check Status Indicators

To complete this procedure, follow these steps.

1. Apply chassis power as shown in the figure.

2. Check the power supply and module status indicators and

alphanumeric display to determine that the power supply and module

are operating properly.

The alphanumeric display should cycle through the following states:

TEST -

PASS - OK - REV x.x, where x.x is the module’s firmware

revision.

ATTENTION