Instruction Manual

96 Rockwell Automation Publication 1756-UM514C-EN-P - June 2014
Chapter 8 Messaging Between ControlLogix Controllers
Configure the Module Switches
In this application, Channel B on the 1756-DHRIO and 1756-DHRIOXT
modules must be set for DH+.
Configure Message Instructions
Use the Studio 5000 environment to configure the ControlLogix controller
message instructions. The following figure shows the message instructions
necessary for this example.
Configuration Tab Communication Tab
IMPORTANT
When you are using the 1756-DHRIO for CIP messaging, no link ID numbers
are present. You must use an explicit message path.