Instruction Manual

64 Rockwell Automation Publication 1756-UM514C-EN-P - June 2014
Chapter 4 Using Programming Software in DH+ Applications
Connection path examples
The following examples are based on this system:
Programming
Terminal
serial DH+ Ethernet Control-
ControlNet = port 2
Serial
ControlNet
Ethernet
DH+
ControlNet module Ethernet module DH+ module controller module ControlNet module Ethernet module DH+ module
ControlNet = Node 49
ControlNet module Ethernet module DH+ module controller module
ControlNet = Node 42
Port 1 = Backplane
Port 2 = ControlNet
Local Chassis
Remote Chassis
41027
Ethernet IP Address = 21.21.21.21
DH+ = Port 0
Ethernet IP Address = 34.34.34.34
DH+ = Node 037
DH+ = Node 24
Port 1 = Backplane
Port 2 = Channel A = Node 025
Port 3 = Channel B = Node 026
Ethernet IP Address = 127.127.127.12
Port 1 = Backplane
Port 2 = Ethernet