Instruction Manual

Rockwell Automation Publication 1756-UM514C-EN-P - June 2014 45
Chapter 4
Using Programming Software in DH+
Applications
What This Chapter Contains
This chapter describes how to use programming software with your
1756-DHRIO and 1756-DHRIOXT modules in DH+ applications, including a
brief discussion of how to use each. For more information on these software, see
the online help in each.
Select the Correct Software
The programming software you need is dependent on what products you are
using with the 1756-DHRIO and 1756-DHRIOXT modules. The following
table explains what software is needed for your application.
Topic: Page
Use RSLinx to Create a Routing Table 46
Use RSLinx Software to Send Control and Information Protocol
Messages
51
Use RSLogix 5 52
Use RSLogix 500 55
Use the Studio 5000 Environment 58
Define Connection Paths 63
If you are using this product with the 1756-DHRIO
module to read/write data in a DH+ application:
You must use this software:
PLC controllers RSLinx®
RSLogix 5
SLC controllers RSLinx
RSLogix500
ControlLogix controllers RSLinx
Studio 5000 environment