Instruction Manual

Rockwell Automation Publication 1756-UM514C-EN-P - June 2014 133

Using the Studio 5000 Environment in Remote I /O and Block Transfer Applications Chapter 10

8. To create a Block Transfer Write message, change the message

configuration as shown below.

9. Set the communication path for the message instruction.

1. Choose the Message Type from the

pull-down list.

2. Specify the Source Element. You can:

• Choose an element from the pull-

down (that is browse to the tag)

• Use the New Tag button to create

the tag where data is written to on

the remote module.

3. Type the Number of Elements being

written.

If you create a Tag, you must:

1. Name the tag.

2. Make sure the Data Type is Integer

(INT).

1. Use the Browse button to select the

path.

2. Select the destination module for the

message instruction.

3. Click OK.