Installation Instructions Owner manual
22 ControlLogix-XT ControlNet Interface Module
Publication
1756-IN634A-EN-P - April 2009
Set Up the USB Driver
To configure RSLinx software to use a USB port, first set up a USB
driver by performing this procedure.
1. Connect your 1756-CN2RXT module to your workstation by
inst
alling a USB cable in your module’s USB port.
The workstation monitor displays the Found New Hardware
W
izard dialog box.
2. Click Install the software automatically (Recommended) and
clic
k Next.
The software is installed.
3. Click Finish to set up your USB driver.
4. To view your 1756-CN2RXT module in RSLinx software, click
the RSWho
button.
The RSLinx Workstation organizer appears.
Your 1756-CN2RXT module appears under two different
driv
ers, a virtual chassis and the USB port. You can use either
driver to browse through to your ControlNet module.
Virtual
Chassis
Driver
USB Port
Driver