Instruction Manual

Publication 1753-UM001C-EN-P - March 2010 135

Use the Control Panel to Monitor Status Chapter 14

Control Panel Resource

To modify the safety settings of the controller, choose Safety from the

control panel’s Resource menu .

IMPORTANT

Any settings you change via the Resource menu are directly

updated in the controller and are saved in the project.

Menu Item Description

Check Consistency Compares the program running in the controller with the program you are editing in

RSLogix Guard PLUS! software. If they match, your offline project has previously been

downloaded to the GuardPLC controller.

Set Main Enable Lets safety parameters be changed. You can only choose Set Main Enable when the

controller is in Stop mode.

For more information, see page 119

Reset Main Enable Prevents safety parameters from being changed.

For more information, see page 119

Change Safety Parameters Changes the safety parameters, if Set Main Enable is activated.

You must have Read/Write or Administrator access to be able to change safety

parameters.

For more information about these parameters, see page 119

TIP

Refer to the Using RSLogix Guard PLUS! Software with

GuardPLC Controllers Programming Manual, publication

1753-PM001

, for more information on the Warmstart, Coldstart,

Stop, and Download menu items.