Instruction Manual

Publication 1753-UM001C-EN-P - March 2010 131
Use the Control Panel to Monitor Status Chapter 14
EIP Protocol Tab
This Field Displays
Peer IP IP address of communication partner
Peer Status Status of Peers, either Run or Idle.
If peer does not provide run idle information, nothing can be displayed!
Connection Type Displays the Connection Type, Originator or Target, that the controller acts as in this connection.
Connection State The status of connection.
• 1 = Connecting Configuring – In the process of opening a new connection.
• 2 = Spare
• 3 = ConnectionEstablished – Connection is active.
• 4 = ConnectionTimedOut – Connection has timed out; will stay in this state at least for some time if
WatchdogTimeoutAction is set to TimeoutManualReset or TimeoutDelayAutoReset.
• 5 = ConnectionDeferredDelete – Connection is about to be deleted and waiting for child connections to be
closed first.
• 6 = ConnectionClosing – In the process of closing the connection.
Input Associated input assembly Id with the connection or 0 if none. For scanner connections of the controller these field
shows the assembly id data is read from.
Output Associated output assembly id with the connection or 0 if none. For scanner connections of the controller these
field shows the assembly id data is written to.
Sent Number of sent packets on this connection.
Counter wraps with 2
32
packets.
Received Number of received packets on this connection.
Counter wraps with 232 packets.
Bad Messages Number of received or dropped messages for that connection. You can reset this value by pressing Counter Reset.
PRPI Produced Requested Packet Interval (µs).
CRPI Consumed Requested Packet Interval (µs).
MinPITime Minimum Packet Interval Time (µs).
MaxPITime Maximum Packet Interval Time (µs).
LastPITime Last Packet Interval Time (µs).
AvrPITime Average Packet Interval Time (µs).