Instruction Manual

1 Publication 1753-PM001A-EN-P - November 2005

Chapter

Create a GuardPLC Project

In This Chapter

This chapter guides you through the following basic steps required to

create a project:

• Start a new project.

• Configure the project and hardware.

• Create signals.

• Connect signals to the I/O points.

• Create a Function Block program using the signals.

• Save, compile, test, and download the program to the GuardPLC

controller.

• Monitor the project online.

Start a New Project

To start a new GuardPLC project:

1. Start RSLogix Guard PLUS! software.

2. Create a new project using the New icon or by choosing

Project>New.

3. Enter ‘FirstProject’ in the Object Name field as shown below and

click OK.

The Hardware Management window opens. This window is

used to configure the project, controller, I/O, and signals.