Safety Scanner for GuardPLC Controllers User Manual

Publication 1753-UM002A-EN-P - July 2005
Index
Symbols
.ssf
See scanner signals file.
.tcf
See target connections file.
Numerics
1753-CBLDN 2-7
1770-KFD module 1-5
1784-PCD 1-5
1784-PCID 1-5
A
A#xx 10-2
add connections 5-3
add devices
available devices list
5-9
advanced safety connection properties
5-5
associate 7-1–7-5
manually 7-4–7-5
automap 5-9
automatically update signals 7-2–7-3
available devices list 5-9
add devices 5-9
B
baud rate
reset
3-4
See communication rate.
bridge device
1-5
bus off detected 10-3
C
change of state
definition
messages
1-2
CIP safety protocol
definition
G-1
COMM3 port 2-7
communication connections 2-5
communication rate 1-8
choose 1-9
set 1-9
compile logic 8-4
configuration
DeviceNet Safety I/O target nodes
5-2
DeviceNet Safety Scanner safety
connections
5-3
DeviceNet Safety Scanner standard
connections
5-6
DeviceNet Safety target nodes 5-1
DeviceNet Standard slave nodes 5-6
GuardPLC controller connections 5-12
HSP connnection 8-3
safety parameters 5-2
signals 8-1
standard inputs 5-10
standard outputs 5-11
standard parameters 5-3
standard scanner inputs 5-10
verify 9-1–9-7
configuration owner
reset
3-4
configuration signature 1-1, 5-1
comparison 9-6
components 5-1
definition 5-1, G-1
mismatch 9-2
configure a driver 3-1
connect safety signals 8-2
connect signals 8-1
connection reaction time limit 5-4
and network delay multiplier 5-5
DeviceNet Safey I/O 5-4
connections
add
5-3
controller ID 5-12, 7-4
and system ID 6-4
default 1-2
definition G-1
controller receive timeout
set
6-3
controller resend timeout
definition
G-1
set 6-3, 6-4
cooling 2-2
COS
See change of state.
create a GuardPLC project
6-1
create a scanlist 5-8
create a signal 8-2
create application program logic 8-4
cyclic
definition
G-1
messages 1-2
cyclic messages 1-3