Safety Scanner for GuardPLC Controllers User Manual

Publication 1753-UM002A-EN-P - July 2005
B-4 Configure Peer-to-Peer DeviceNet Communications
4. Add HSP protocol to the peer resource.
5. Configure HSP communications. Right-click on the peer HSP
Protocol and select Properties.
See page 6-3 for an explanation of the HSP communication
parameters.
6. Review the peer controller’s communication settings. See page
6-5.
Define Target Connections
for Standard and Safety
Data
To support peer-to-peer communication, you must assign application
signals to define target connections to which a peer scanner or other
CIP Safety originator or standard master will connect. Review the
guidelines for creating a distinction between safety and standard
signals on page 1-4.