User guide

Publication 1747-UM013B-EN-P - January 2005
Index 3
N
noise immunity A-1
O
operation
run mode
3-8
startup 3-8
operation modes
changing
3-8
overview
M files
4-14
P
power consumption A-1
programming scanner 4-33
R
rack boundaries
crossing logical
4-13
remote I/O
configuration considerations
4-12
remote output reset control 4-20
removing the scanner 3-4
required tools and equipment 2-1
retry counters 6-2
RIO baud rate status 4-24
RIO block transfer - what it is 5-1
RIO device reset control 4-18
RIO image files 4-1
RIO link
physical and logical specifications
1-9
RIO link connector 1-19
RIO link wiring 3-3
RIO scan time
throughput
A-4
rules
configuration
4-7
run mode
operation
3-8
S
scanner
asynchronous operation
1-4
G file configuration 4-4
I/O image division 1-3
image files 4-1
insertion 3-3
interacting with adapters 1-2, 1-5
interaction with adapters 1-5
operating with SLCs 1-4
output delay time
with block transfer
A-7
without block transfer A-13
scanning remote I/O 1-4
scanner I/O image
concepts
1-6
selecting
baud rate
3-2
setting up scanner 4-33
G file 4-4
slot addressing 4-32
specifications
baud rate
A-1
dip switch settings A-1
humidity A-1
noise immunity A-1
operating temperature A-1
power consumption A-1
storage temperature A-1
startup 3-7
operation 3-8
start-up instructions 2-1
status table
LEDs
3-9
steps for programming scanner 4-33
T
table
bits, baud rate, switch settings
4-24
error codes 6-1
LEDs 6-1
temperature
operating
A-1
storage A-1
terms E-1
throughput A-2
calculating throughput A-3
block transfer A-11
with block transfers present A-6,
A-11
without block transfers present A-3
introduction A-2
tools needed 2-1
transferring data
block transfer
1-9
discrete 1-9
troubleshooting 6-1
communication problems 6-2