User Manual Instruction Manual

79 Publication 1747-UM655B-EN-P - June 2007

Chapter

Creating and Running the Example

Application Program

What This Chapter Contains

This chapter describes the procedure to create, download, and run an

example ladder logic program to test the DeviceNet network. When

the processor is put into Run mode, pressing the START button on the

network’s RediSTATION operator interface will cause the red indicator

light to come on and stay on until the STOP button is pressed. Passing

an object in front of the photoeye will increment a counter.

Recall that you cannot directly communicate with the SLC 500

processor over the DeviceNet network. This chapter shows how to

download and run the program over a ControlNet, Ethernet, or Data

Highway Plus network.

The SLC 500 I/O chassis used for these examples was set up with the

following hardware.

The following table describes what this chapter contains and where to

find specific information.

Chassis Setup

Module Slot DH+

Address

Ethernet

Address

ControlNet

Address

DeviceNet

Address

SLC 500 5/04

Processor

(1)

Used for Data Highway Plus and ControlNet examples.

01 - - -

SLC 500 5/05

Processor

(2)

Used for Ethernet example.

0 - 130.130.130.2 - -

1747-KFC15 1 - - 16 -

1747-SDN 2 - - - 0

Topic Page

Install the Software 80

Create the Example Application Program 80

Download and Run the Program 82