Manual

5–5 Using RS232-to-Ethernet

Channel-to-Channel Passthru
Publication 1747-10.4
SLC 5/03 Channel Configurations
• Channel 0 Driver is set to DF1 Full Duplex.
• Source ID is the address of the sender of the message. It can be
any number from 0 to 254.
SLC
5/05 #1 Bridge
Ladder logic is not required for the SLC 5/05 which acts as the
bridge from DF1-to-Ethernet. However, you must set up a passthru
routing table when configuring the bridge. The channel configuration
is shown below, followed by the routing table on
page 5–7.
SLC 5/05 #1 Bridge Channel Configuration