User Manual

Publication 1747-UM005B-EN-P - March 2006

Module Configuration Using the Backplane 6-15

Modem Init String for Characters 15 Through 28

Build the configuration in the table shown below if you need to use

characters 15 to 28 of the Modem Init String. Please note that sending

a ~ character produces a one second wait on the modem.

SLC Output File to the Interface Module

Bit

Word

15 14 13 12 11109876543210

(1)

Module

Mode

Bit

Data

Hand

shake

Bit

Read or

Write

Bit

Reset

Interface

Module

Bit

Reserved Data ID=5

1 15th ASCII character 16th ASCII character

2 17th ASCII character 18th ASCII character

3 19th ASCII character 20th ASCII character

4 21st ASCII character 22nd ASCII character

5 23rd ASCII character 24th ASCII character

6 25th ASCII character 26th ASCII character

7 27th ASCII character 28th ASCII character

(1)

The output status word is defined on page 6-6. To configure the Modem Init String, the Read or Write Bit must be at 0 and the Module Mode Bit must be

at 1. To read the Modem Init String, the Read or Write Bit must be 1 and the Module Mode Bit can be either 0 or 1.