User Manual

Publication 1747-UM005B-EN-P - March 2006
5-8 Module Configuration Using an ASCII Terminal
DF1 Protocol Menu
When you press [4] to select the DF1 Protocol Menu, you are first
prompted at the bottom of the Top Level Setup Menu to select [H] or
[F] for half- or full-duplex.
DF1 Protocol Menu
DF1 Full-duplex Setup Menu
Select full-duplex by pressing [F] when prompted at the bottom of
the Top Level Setup Menu. The DF1 Full-duplex Setup Menu provides
12 selections.
DF1 Full-duplex Setup Menu
IMPORTANT
Choose [F] for full-duplex when using RSLinx
software.
Enter Selection. . . . .4
1. CONFIG PORT
2. DF1 PORT
3. DH 485 PORT
4. DF1 PROTOCOL
5. DISPLA Y P ARAMETERS
X. SA VE AND EXIT
DF1 Duplex = Full, New V alue (H/F) =
DF1 Full Duplex Setup Menu
1. Duplicate Packet Detection
2. Checksum
3. Constant Carrier Detect
4. Modem Init String
5. Modem Init String Delay
6. Message T imeout
7. Hardware Handshaking
8. Embedded Response Detect
9. ACK T imeout
A. ENQuiry Retries
B. NAK Received Retries
X. SA VE AND EXIT
Enter Selection. . . . .