User Manual

Publication 1747-UM005B-EN-P - March 2006
Module Configuration Using an ASCII Terminal 5-3
Module Configuration with
a Terminal Overview
Configuration of the module with an ASCII terminal requires:
• an ASCII terminal connected to the CONFIG port.
• jumper JW4 to be in the configuration position.
See page 4-4 for more information.
• knowledge of the communication parameters of the devices you
will be connecting to each of the module ports.
• knowledge of what types of cables will be used to connect
devices to the module ports.
Refer to the cable information beginning on page 4-8.
When you power up the module and your ASCII terminal, a Top Level
Setup menu appears. The menu structure is three levels deep.
Menu Structure
DF1
Protocol
Setup
Half-duplex
Setup
Full-duplex
Setup
Top Level
Setup
Menu
CONFIG Port
Setup
DF1 Port
Setup
DH-485 Port
Setup
Display
Parameters