Installation Instructions Instruction Manual

ManualsBrandsRockwell Automation ManualsEquipment1746-SIM SLC 500 Input Simulator

Publication 1746-IN024A-EN-P - October 2001

Installation Instructions

SLC 500 Input Simulator

(Catalog Number 1746-SIM)

Application

The SLC 500 Input Simulator is designed for use on 16-point, 24V dc input modules

that incorporate a removable terminal block (RTB). The following table lists the

SLC 500 modules that may be used with the Input Simulator Module.

Catalog Number Module Description

1746-IB16 Current Sinking DC Input Module

1746-ITB16 Fast Response Current Sinking DC Input Module

1746-IV16 Current Sourcing DC Input Module

1746-ITV16 Fast Response Current Sourcing DC Input Module

1746-IN16 24V AC/DC (sinking) Input Module

1746IN024AENP.fm Page 1 Tuesday, December 4, 2001 11:26 AM

Summary of content (4 pages)

PAGE 1
746IN024AENP.fm Page 1 Tuesday, December 4, 2001 11:26 AM Installation Instructions SLC 500 Input Simulator (Catalog Number 1746-SIM) Application The SLC 500 Input Simulator is designed for use on 16-point, 24V dc input modules that incorporate a removable terminal block (RTB). The following table lists the SLC 500 modules that may be used with the Input Simulator Module.
PAGE 2
1746IN024AENP.fm Page 2 Tuesday, December 4, 2001 11:26 AM 2 SLC 500 Input Simulator Installing the Input Simulator ATTENTION Installing the 1746-SIM on a module other than those listed above can damage the module and expose you to hazardous voltages. ! ATTENTION Never install or remove RTBs (removable terminal blocks) or modules while power is applied to the SLC system. ! 1. Remove the RTB from the input module. To avoid cracking the RTB, alternate between the two release screws when loosening.
PAGE 3
1746IN024AENP.fm Page 3 Tuesday, December 4, 2001 11:26 AM SLC 500 Input Simulator 3 2. Mount the 1746-SIM on the input module. Align the Input Simulator release screws with the mating connector on the module and press the Input Simulator firmly onto the connector contacts. To avoid damage to the Input Simulator connector/RTB, alternate between the two screws when tightening. Secure the Input Simulator to the input module with the captive screws. Alternate tighening to avoid damage. 11/64 inch dia.
PAGE 4
1746IN024AENP.fm Page 4 Tuesday, December 4, 2001 11:26 AM For More Information For Refer to this Document Pub. No. A more detailed description on how to install and use your modular SLC 500 system. SLC 500 Modular Hardware Style Installation and Operation Manual 1747-UM011C-EN-P Detailed information on installing and wiring discrete I/O modules in an SLC system.